JC100

JC100
Manufacturer: Jimi IoT (Concox)
Discontinued

Number of units

3
Online
15
Total
Supported in Wialon:
  • Camera connection
  • Live stream
  • Communication via TCP

The following data should also be added to JC100 unit properties section of Wialon GPS tracking software :

Device type: JC100
Unique ID: imei

Specify the following parameters in configuration software or configuration JC100 for use in Wialon Hosting :

Server port: 21607

15 units of JC100 device type are connected to Wialon Data Center. This represents 0.15% of all Video monitoring connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name Description Units
alarm_type Alarm Type:
1: SOS alarm
9:displacement alarm
128: vibration alarm
129:Excess data traffic alarm
130:Device reboot
131:collision alarm
132: forward camera abnormal
133: inward camera abnormal
134:SD card can’t be identified
135:overspeed alarm
136:power off alarm
137: no inward camera
138:Enable power/oil cutoff alarm
139:Disable power/oil cutoff alarm
144: harsh acceleration alarm
145: harsh deceleration alarm
146:sharp turn alarm
147: collision alarm
mcc Mobile Country Code
mnc Mobile Network Code
lac Location Area Code
cell_id Cell Tower ID
voltage_lvl The range is 0~6 defining the voltage is from low to high.
0: No Power (shutdown)
1: Extremely Low Battery
2: Very Low Battery
3: Low Battery
4: Medium
5: High
6: Very High
gsm GSM Signal Strength Levels
0: no signal;
1: extremely weak signal;
2: very weak signal;
3: good signal;
4: strong signal.
tr_status Bitmask representing different terminal statuses.
Bit7
1:Oil/Electricity cutoff
0:Oil/Electricity on
Bit6
0: GPS tracking is off
1: GPS tracking is on
Bit3~Bit5
Extended bit
Bit2
0: Charge Off
1: Charge On
Bit1
1: ACC high
0: ACC Low
Bit0
0: Disarm
1:Arm
acc 1: ACC high
0: ACC Low
up_mode Data Upload Mode:
(could be only one mode available)
0 upload by time interval
1 upload by distance
2 upload for corner correction
3 upload by ACC status change
4 Re-upload last valid locating point after shift from dynamic motion to static position
5 Report last valid locating point after network reconnected.
6 Update the ephemeris to upload locating point.
7 Press to upload locating point
8 Power on to upload locating point
9 Power on and change locating point by GPS based station.

How to configure JC100/JC200 device in Wialon

Photo and video (up to 20 seconds) request is available

More devices from the manufacturer

News

Contact Gurtam and achieve the most ambitious goals with telematics

Fill out a request form to get started with Wialon

Step 1
Step 2
Step 3
First and last name*
Company*
Email*
Phone