Number of units
The following data should also be added to Concox GV26 unit properties section of Wialon GPS tracking software :
| Device type: | Concox GV26 |
| Unique ID: | imei |
Specify the following parameters in configuration software or configuration Concox GV26 for use in Wialon Hosting :
| Server port: | 22032 |
4009 units of Concox GV26 device type are connected to Wialon Data Center. This represents 0.19% of all AVL Hardware connected.
Below chart represents the dynamic of connections in the last 30 days:
| Parameter name | Description | Units |
|---|---|---|
| alarm | Alarm status: 0: normal 1: SOS 2: Power Cut Alarm 3: Vibration Alarm 4: Fence In Alarm 5: Fence Out Alarm 6: Over-speed Alarm 9: Moving Alarm 41: Harsh acceleration alarm 42: Sharp Left Turn 43: Sharp Right Turn 48: Harsh deceleration alarm |
|
| alarm_status | Alarm status: 0: Normal 1: Shock Alarm 2: Power Cut Alarm 3: Low Battery Alarm 4: SOS |
|
| mcc | Mobile Country Code | |
| mnc | Mobile Network Code | |
| lac | Location Area Code | |
| cell_id | Cell Tower ID | |
| voltage | Voltage degree 0-6: 0: Lowest power and power off 1: No enough power to dial a call or send messages. 2: Low power and alarm 3: Lower power but can work normally 3~6: Work in good condition |
|
| gsm | GSM signal strength degree | |
| alm1 | Bitwise parameter (1 - ON, 1 - OFF): bit1 - SMS Alarm bit2 - Phone Alarm bit3 - Network Alarm bit4 - Displacement Alarm bit5 - SMS Alarm bit6 - Phone Alarm bit7 - Network Alarm bit8 - Vibration Alarm |
|
| alm2 | Bitwise parameter (1- ON, 0 - OFF): bit1 - SMS Alarm bit2 - Phone Alarm bit3 - Network Alarm bit4 - Low Battery Alarm bit5 - SMS Alarm bit6 - Phone Alarm bit7 - Network Alarm bit8 - Low Battery Alarm |
|
| alm3 | Bitwise parameter (1 - ON, 0 - OFF): bit1 - SMS Alarm bit2 - Phone Alarm bit3 - Network Alarm bit4 - Power Off Alarm bit5 - SMSAlarm bit6 - Phone Alarm bit7 - Network Alarm bit8 - Overspeed Alarm |
|
| sta1 | Bitwise parameter (1 - ON, 0 - OFF): bit1 - Disassembly Alarm Status bit2 - Disassembly bit5 - Remotely Disarm bit6 - Manually Arm bit7 - Automatically Arm bit8 - Arm Status |
|
| dyd | Fuel/Electricity, Cutoff Status ( 1 - Valid, 0 - Invalid): bit1 - Oil/Electricity connection bit2 - Oil/Electricity cutoff bit3 - Deferred execution caused by GPS unlocated bit4 - Deferred execution caused by overspeed |
|
| sos_numN | SOS number | |
| center_num | Center number | |
| fence | Fence | |
| mode | Mode |
