GPS tracker Queclink GV56RS | Integrated with Wialon

Supported in Wialon:

Communication via TCP
Communication via UDP

The following data should also be added to Queclink GV56RS unit properties section of Wialon GPS tracking software :

Device type:	Queclink GV56RS
Unique ID:	imei

Specify the following parameters in configuration software or configuration Queclink GV56RS for use in Wialon Hosting :

Server port:

21730

680 units of Queclink GV56RS device type are connected to Wialon Data Center. This represents 0.03% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name

Description

Units

dev_type

Queclink device type
*HEX mode only

proto_ver

Queclink protocol version
*HEX mode only

fw_ver

Firmware version
*HEX mode only

battery

Battery level, 0-100

pwr_ext

External power source voltage

adc_mode

Analog Input Mode

adc1

Analog Input 1 voltage

din_status

Digital Input (bit mask)

dout_status

Digital Output (bit mask)

motion_status

17 (0x11) Ignition off Rest: The vehicle is ignition off and motionless.
18 (0x12) Ignition off Motion: The vehicle had been moving before this action was regarded as car-towing event after ignition off.
33 (0x21) Ignition On Rest: The vehicle is ignition on and motionless.
34 (0x22) Ignition On Motion: The device is ignition on and moving.
65 (0x41) Sensor Rest: The vehicle is motionless and no ignition signal is detected.
66 (0x42) Sensor Motion: The vehicle is moving and no ignition signal is detected.
22 (0x16) Tow: The vehicle was towed after ignition off.
26 (0x1A) Fake Tow: The vehicle might have been towed after ignition off.

phone_number

ign_dur

ibutton

ibutton_auth

geo_id

ges_enabled

ges_mode

ges_radius

ges_dt

geo_area_type

geo_mask_group

geo_area_mask_group_1

geo_area_mask_group_2

jamming_cw

jamming_gps

upc_cmd_id

upc_result

url

x_forward

y_forward

z_forward

x_side

y_side

z_side

x_vert

y_vert

z_vert

onewire[i]_id

onewire[i]_type

onewire[i]_data

fuel_sensor[i]_type

fuel_sensor[i]_id

fuel_sensor[i]_percent

fuel_sensor[i]_volume

pwr_int

jamming_status

crash_counter

upd_code

upd_retry

idle_dt

gps_signal_status

wave1_out_id

wave1_out_active

temp_alarm_id

temp_status

temp_device_id

temp_device_data

roaming_state

curr_mileage

Current Trip Mileage
*HEX mode only

total_mileage

Total Mileage
*HEX mode only

curr_hourmetercount

Current Trip Hour Meter Count (accumulative ignition time)
*HEX mode only

total_hourmetercount

Total Hour Meter Count (accumulative ignition time)
*HEX mode only

hw_ver

mcu_ver

fri_discard_no_fix

resp_report_mask

ign_dt

igf_dt

bat_status

iccid

the ICCID of the SIM card

csq_ber

CSQ BER,0-7/99

daylight_saving

time_zone

tcp_cmd_count

udp_cmd_count

sms_cmd_count_white

sms_cmd_count

tcp_msg_count

udp_msg_count

sms_msg_count_white

sms_msg_count

gir_trigger

mcc[i]

mnc[i]

lac[i]

cell_id[i]

ta[i]

rx_level[i]

gps_level

jamming_indicator

sat_[sv_id]

local_ip

ign_on_duration

Duration since last time the ignition is on

ign_off_duration

Duration since last time the ignition is off

report_type

The message type of ASCII format report

device_status

16 (Tow) The device attached vehicle is ignition off and it is towed.
1A (Fake Tow) The device attached vehicle is ignition off and it might be towed.
11 (Ignition Off Rest) The device attached vehicle is ignition off and it is motionless.
12 (Ignition Off Motion) The device attached vehicle is ignition off and it is moving before it is considered to be towed.
21 (Ignition On Rest) The device attached vehicle is ignition on and it is motionless.
22 (Ignition On Motion) The device attached vehicle is ignition on and it is moving.
41 (Sensor Rest) The device attached vehicle is motionless without ignition signal detected.
42 (Sensor Motion) The device attached vehicle is moving without ignition signal detected.

eri_mask

This mask is used to configure whether to report the data from peripherals via +RESP:GTERI

csq_rssi

the level of signal strength

pwr_s

whether the external power supply is connected.

charging

Wheter the backup battery is charging when the main power supply is connected

ledon