Queclink GV500

Queclink GV500
User rating

(10 Votes)

Forum Discussion

Number of units

Features Queclink GV500:
  • Blackbox
  • Built-in odometer
Supported in Wialon:
  • CAN-bus support
  • Remote management via GPRS
  • LBS
  • Remote management via SMS
  • Communication via TCP

The following data should also be added to Queclink GV500 unit properties section of Wialon GPS tracking software:

Device type: Queclink GV500
Unique ID: imei

Specify the following parameters in configuration software or configuration Queclink GV500 for use in Wialon Hosting:

Server IP Address:
Server port: 20732

466 units of Queclink GV500 device type are connected to Wialon Data Center. This represents 7.62% of all OBD trackers connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name Description Units
battery The current volume of the backup battery %
call_number The phone number of the incomming call
charging Whether the backup battery is charging when the main power supply is connected.
0 - not charging
1 - charging
csq_ber The quality of the GSM signal. The range is 0-7, 99 for unknown
csq_rssi The GSM signal strength level. The range is 0-31, 99 for unknown
curr_hour_meter The current hour meter count h
curr_mileage The current mileage km
data_type The data reported to backend server is recorded before or after crash:
0 - before crash
1 - after crash
dev_type The type of device
dtcs_cleared_dist The distance accumulated since DTCs were cleared km
dtcs_num Number of DTC codes
engine_coolant_temp The engine coolant temperature °C
engine_load Indicates a percentage value of peak available torque. Reaches 100% at wide open throttle at any altitude or RPM for both naturally aspirated and boosted engines %
engine_rpm Revolutions per minute of the engine RPM
ext_pow_supply Whether the external power supply is connected.
0 - not connected
1 - connected
fuel_consumption The fuel consumption L/100km
fuel_level_input Indicates the nominal fuel tank liquid fill capacity as a percent of maximum %
gps_acc GPS accuracy
gps_signal GPS signal status:
0 - lost GPS signal or no successful GPS fix
1 - GPS signal recovered and successful GPS fix
hard_ver The hardware version
harsh_behavior Harsh behavior:
0 - harsh braking behavior
1 - harsh acceleration behavior
2 - harsh turn behavior
3 - harsh brake and turn behavior
4 - harsh acceleration and turn behavior
5 - unknown harsh behavior
harsh_speed_level The speed level of which the harsh behavior is detected:
0 - unknown speed
1 - low speed
2 - medium speed
3 - high speed
hour_meter_count The total hour meter count h
idling The time that the vehicle has been in idling status s
ign Ignition state: 0 - off, 1 - on
ign_off_duration Duration since last time the ignition is off s
ign_on_duration Duration since last time the ignition is on s
jamming_status The current Jamming status of the device.
1 - quit the jamming
2 - enter the jamming
led_on Whether the LED’s are turned on.
0 - off
1 - on
mil_activated_dist The distance accumulated since MIL is activated km
mileage The total mileage km
mil_status Malfunction Indicator Lamp (MIL) status:
0 - off
1 - on
obd_connect Whether the device is connected with vehicle.
0 - not connected
1 - connected
obd_mileage Calculated by distance read from OBD
obd_pwr The voltage from the vehicle via OBDII interface V
obd_speed Vehicle road speed km/h
packet_type Report packet type
pids Parameter identifications (PID) are supported
pwr_ext The voltage of the external power supply V
pwr_int The voltage of the backup battery. The value of this field is only valid when the external power is not connected V
soft_ver The software version
state The current motion state of device:
16 - Tow
1A - Fake Tow
11 - Ignition Off Rest
12 - Ignition Off Motion
21 - Ignition On Rest
22 - Ignition On Motion
41 - Sensor Rest
42 - Sensor Motion
throttle_pos Indicates a percentage of throttle position sensor value. Usually above 0% at idle and less than 100% at full throttle %
time_zone Time zone offset
trouble_codeN Diagnostic Trouble Code (DTC)
vin Vehicle identification number
x_axisN The X axis acceleration m/s2
y_axisN The Y axis acceleration m/s2
z_axisN The Z axis acceleration m/s2

Queclink GV500VC should be configured like Queclink GV500.

More devices from the manufacturer