Queclink GL100M

Queclink GL100M
User rating

(4 Votes)

Forum Discussion

Number of units

15
Online
33
Total
Features Queclink GL100M:
  • Blackbox
Supported in Wialon:
  • Remote management via GPRS
  • LBS
  • Remote management via SMS
  • Communication via TCP

The following data should also be added to Queclink GL100M unit properties section of Wialon GPS tracking software:

Device type: Queclink GL100M
Unique ID: imei

Specify the following parameters in configuration software or configuration Queclink GL100M for use in Wialon Hosting:

Server IP Address: 193.193.165.165
Server port: 20433

33 units of Queclink GL100M device type are connected to Wialon Data Center. This represents 0.26% of all Personal trackers connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name Description Units
battery Battery level %
ber The quality of GSM signal
charger Whether the battery is charging when the external power supply is connected:
0: Not charging
1: Charging
charging Whether the battery is charging when the external power supply is connected:
0: Not charging
1: Charging
external_pwr External power supply:
0: Not connected
1: Connected
flash_type A numeric to indicate what the type of flash is:
0: SST flash
1: NMX flash
gps_antenna_type A numeric to indicate which GPS antenna is working now
0: inside GPS antenna
gps_on_need Whether to close GPS chip after retrieving GPS position information:
0: Never close GPS chip
1: Close GPS chip after retrieving GPS information every time
2: Never close GPS chip only in ignition on state or movement state
3: Never open GPS chip
gsm_level The GSM signal strength level
gsm_quality The quality of GSM signal
hdop Horizontal Dilution of Precision
ign Ignition state: 0: off, 1: on
ign_off_duration Duration since last time the ignition is off s
ign_on_duration Duration since last time the ignition is on s
led_on The working mode of LEDs
mileage The total mileage km
movement_cause The enter movement cause defines the factor who triggers the message:
0: Triggered by motion sensor detection. It is defaulted
1: Triggered by RTO sub command RTL
2: Triggered by the command GTLSW from EBK
movement_state 0: The state of the device changed from motion to rest
1: The state of the device changed from rest to motion
odo_mileage The total mileage in the position km
pwr_int Battery voltage V
report_type Message type
rssi The GSM signal strength level
state The current motion state of the device:
21: The device attached vehicle is ignition on and motionless
22: The device attached vehicle is ignition on and moving
41: The device is motionless without ignition on
42: The device is moving without ignition on
temp_int The temperature of the device °C

More devices from the manufacturer

News