OBD tracker Xirgo XT-2469 (CoAP) | Integrated with Wialon

The following data should also be added to Xirgo XT-2469 (CoAP) unit properties section of Wialon GPS tracking software :

Device type:	Xirgo XT-2469 (CoAP)
Unique ID:	custom

Specify the following parameters in configuration software or configuration Xirgo XT-2469 (CoAP) for use in Wialon Hosting :

Server port:

22048

0 units of Xirgo XT-2469 (CoAP) device type are connected to Wialon Data Center. This represents 0% of all OBD trackers connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name	Description	Units
tz	Time zone offset.Number of 15-minute increments from UTC.
hp	PDOP in tenths
ev	Event identifier: 0 - Reserved 1 - Ignition On / Trip Start / Engine On 2 - Ignition Off / Trip End / Engine Off 3 - Ignition On Periodic Report 4 - Ignition Off Periodic Report / Heartbeat 5 - Power-up Message 6 - Power-up Message on GPS Lock 7 - Power-up Message on GSM 8 - Low Battery Alert 9 - Accelerometer Shock Event 10 - Acceleration based on VBUS speed 11 - Acceleration based on GPS speed 12 - Stage 0 Periodic Event Reporting 13 - Stage 1 Periodic Event Reporting 14 - Stage 2 Periodic Event Reporting 15 - Battery Disconnect Event 16 - Battery Reconnect Event 17 - Battery Periodic Disconnect 18 - Direction Change 19 - Speed VBUS 20 - Speed GPS 23 - Odometer VBUS 24 - Odometer GPS 25 - Input 1 Set 26 - Input 2 Clear 27 - Input 2 Set 28 - Input 2 Clear 31 - Heartbeat 32 - Output Manual Override 33 - Diagnostics 34 - Movement Start 35 - Movement Stop 36 - System Report 0 37 - System Information 38 - Park 39 - Idle Start 40 - Idle Stop 41 - Idle Periodic 42 - Best Time 43 - ADC Threshold 44 - ADC Periodic 45 - Diagnostics 1 46 - Diagnostics 2 47 - Diagnostics 3 52 - Powerstage Transition 53 - Fuel Level Threshold Change
cq	Cellular signal quality.The range of the values is dependent on the cellular module. When the RF power level of the received signal is the highest possible, the value 31 is reported. When it is not known, not detectable or currently not available, 99 is returned.
gs	GPS lock status: 0 - None. Lock status unknown. 1 - Locked. GPS is locked, but the result is filtered. This can mean it has not been locked for enough consecutive solutions or an accuracy figure of merit is unsatisfactory to consider this position LockedGood. 2 - Unlocked. GPS solution is not locked. 3 - LockedGood. GPS solution is locked and integrated. 4 - Sleep. The GPS receiver is powered down. 5 - Filtered. The response has been filtered.
bn	Boot count
pn	Power-loss count
ac	Device acceleration	0.1kmh/s
dc	Device deceleration	0.1 kmh/s
hbe	Device reset reason: 0 - Unknown reset. 1 - Hardware watchdog reset. 2 - Brown-out reset. 3 - Hibernate reset. 4 - User reset. 5 - Software reset. This is initiated by the embedded firmware. 6 - Power on reset. 7 - Main oscillator reset.
hacc	GPS Horizontal accuracy estimate	m
is	Ignition source: 0 - Ignition Unknown 1 - VBUS 2 - Alternator 4 - Accelerometer 8 - GPS MN
mi	Virtual odometer GPS.Calculated mileage	m
gt	GPS time since last lock	s
it	Trip idle time	s
cnt	Trip counter
ch	Configuration hash
ct	Cellular network time.Seconds since 00:00:00 January 1, 1970 UTC. A value of 0 indicates that the current time is not known	s
ut	Device uptime	ms
fwm	Firmware version
si	SIM CCID
imei	Cellular IMEI
im	Cellular IMEI
axyz_x	Accelerometer X-Vector	mg
axyz_y	Accelerometer Y-Vector	mg
axyz_z	Accelerometer Z-Vector	mg
adc#_id	Physical ADC ID: 0 - None 1 - Main voltage 2 - Battery voltage 3 - External ADC 1 4 - External ADC 2 5 - External ADC 3
adc#_flag	Mask of ADC transition states
psti_nxtpst	Power stage transtition information
psti_tps_cnt	Power stage transtition information
bv	Battery voltage	0.1v
loc_ft	Location FixType: 0 - None 1 - GPS
loc_utc	Location epoch time (last known)
loc_hd	Location heading (last known)
loc_qual	Location Dilution of precision (last known)
loc_hacc	Location Horizontal accuracy (last known)

Parameter name

Description

Units

Time zone offset.Number of 15-minute increments from UTC.

PDOP in tenths

Event identifier:

0 - Reserved

1 - Ignition On / Trip Start / Engine On

2 - Ignition Off / Trip End / Engine Off

3 - Ignition On Periodic Report

4 - Ignition Off Periodic Report / Heartbeat

5 - Power-up Message

6 - Power-up Message on GPS Lock

7 - Power-up Message on GSM

8 - Low Battery Alert

9 - Accelerometer Shock Event

10 - Acceleration based on VBUS speed

11 - Acceleration based on GPS speed

12 - Stage 0 Periodic Event Reporting

13 - Stage 1 Periodic Event Reporting

14 - Stage 2 Periodic Event Reporting

15 - Battery Disconnect Event

16 - Battery Reconnect Event

17 - Battery Periodic Disconnect

18 - Direction Change

19 - Speed VBUS

20 - Speed GPS

23 - Odometer VBUS

24 - Odometer GPS

25 - Input 1 Set

26 - Input 2 Clear

27 - Input 2 Set

28 - Input 2 Clear

31 - Heartbeat

32 - Output Manual Override

33 - Diagnostics

34 - Movement Start

35 - Movement Stop

36 - System Report 0

37 - System Information

38 - Park

39 - Idle Start

40 - Idle Stop

41 - Idle Periodic

42 - Best Time

43 - ADC Threshold

44 - ADC Periodic

45 - Diagnostics 1

46 - Diagnostics 2

47 - Diagnostics 3

52 - Powerstage Transition

53 - Fuel Level Threshold Change

Cellular signal quality.The range of the values is dependent on the cellular module. When the RF power level of the received signal is the highest possible, the value 31 is reported. When it is not known, not detectable or currently not available, 99 is returned.

GPS lock status:

0 - None. Lock status unknown.

1 - Locked. GPS is locked, but the result is filtered. This can mean it has not been locked for enough consecutive solutions or an accuracy figure of merit is unsatisfactory to consider this position LockedGood.

2 - Unlocked. GPS solution is not locked.

3 - LockedGood. GPS solution is locked and integrated.

4 - Sleep. The GPS receiver is powered down.

5 - Filtered. The response has been filtered.

Boot count

Power-loss count

Device acceleration

0.1kmh/s

Device deceleration

0.1 kmh/s

hbe

Device reset reason:

0 - Unknown reset.

1 - Hardware watchdog reset.

2 - Brown-out reset.

3 - Hibernate reset.

4 - User reset.

5 - Software reset. This is initiated by the embedded firmware.

6 - Power on reset.

7 - Main oscillator reset.

hacc

GPS Horizontal accuracy estimate

Ignition source:

0 - Ignition Unknown

1 - VBUS

2 - Alternator

4 - Accelerometer

8 - GPS MN

Virtual odometer GPS.Calculated mileage

GPS time since last lock

Trip idle time

cnt

Trip counter

Configuration hash

Cellular network time.Seconds since 00:00:00 January 1, 1970 UTC. A value of 0 indicates that the current time is not known

Device uptime

fwm

Firmware version

SIM CCID

imei

Cellular IMEI

axyz_x

Accelerometer X-Vector

axyz_y

Accelerometer Y-Vector

axyz_z

Accelerometer Z-Vector

adc#_id

Physical ADC ID:

0 - None

1 - Main voltage

2 - Battery voltage

3 - External ADC 1

4 - External ADC 2

5 - External ADC 3

adc#_flag

Mask of ADC transition states

psti_nxtpst

Power stage transtition information

psti_tps_cnt

Power stage transtition information

Battery voltage

0.1v

loc_ft

Location FixType:

0 - None

1 - GPS

loc_utc

Location epoch time (last known)

loc_hd

Location heading (last known)

loc_qual

Location Dilution of precision (last known)

loc_hacc

Location Horizontal accuracy (last known)

Fill out a request form to get started with Wialon

Gurtam products

Niche products for addressing specific tasks

Xirgo XT-2469 (CoAP)

More devices from the manufacturer

News

Contact Gurtam and achieve the most ambitious goals with telematics

Become a partner

Request Wialon in your region

Fill out a request form to get started with Wialon