Skypatrol ST7200

Skypatrol ST7200
Manufacturer: Skypatrol
Forum Discussion

Number of units

23
Online
76
Total
Features Skypatrol ST7200:
  • Blackbox

The following data should also be added to Skypatrol ST7200 unit properties section of Wialon GPS tracking software:

Device type: Skypatrol ST7200
Unique ID: imei

Specify the following parameters in configuration software or configuration Skypatrol ST7200 for use in Wialon Hosting:

Server port: 21445

76 units of Skypatrol ST7200 device type are connected to Wialon Data Center. This represents 0.01% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name Description Units
event_id Event ID:
4001 - Wired Ignition ON
4002 - Wired Ignition OFF
4003 - Virtual Ignition ON
4004 - Virtual Ignition OFF
4005 - Main Battery Disconnect
6001 - Direction Change
6002 - Speed Threshold
6005 - Mileage Threshold
6008 - Main Battery Threshold
6009 - Main Battery Disconnect
6010 - Main Battery Reconnect
6011 - Wired Ignition ON
6012 - Wired Ignition OFF
6013 - Virtual Ignition ON
6014 - Virtual Ignition OFF
6016 - Idle Threshold ON
6017 - Towing Started OFF
6018 - Towing Stopped OFF
6019 - Input 2 High
6020 - Input 2 Low
6021 - Power Shutdown Pending
6022 - Power Shutdown Canceled
6030 - Movement Started
6031 - Movement Stopped
6032 - Parked Time Threshold
6004 - Geofence Crossing
4006 - Heartbeat
6015 - Power Up/Reset
4050 - Diagnostic Data
7001 - Locate Now
7005 - Enable OR Disable Starter Output
3011 - Enable OR Disable Late Payment Buzzer
6026 - Wake on Motion Use last known
6021 - Power Shutdown Pending
hdop HDOP
pwr_ext External Battery Voltage
gps_status GPS Status:
0 – no lock
1 – locked
2 – no comm
3 – GPS OFF (power save mode)
gsm GSM Signal Strength
out_state Output State:
0 – Short circuit with GSM override enabled
1 – Open circuit
2 – Short circuit
miliage Miles driven since last reset or power cycle
ign Ignition Status:
0 – OFF
1 – ON
pwr_int Internal Battery Voltage
last_mode Last Power-up/Reset mode:
1 – S/W Reset
2 – DC Power-Up
3 – Motion Sense
geofenceN Geofence Information with N - Geofence ID number (0 – 9):
1 – outside geofence
2 – inside geofence
fw_v Firmware Version
pf_name Profile Name
gsm_st GSM Registration State:
0 – Not Registered
1 – Home
2 – Search
3 – Denied
4 – Unknown
5 – Roaming
gprs_st GPRS Registration State:
0 – Not Registered
1 – Home
2 – Search
3 – Denied
4 – Unknown
5 – Roaming
gprs_pdp_st GPRS PDP State:
0 – Deactivated
1 – Activated
h_disc Hours Disconnected
h_on Hours ON
pw_up_c Power Up Counter
reset_c Reset Counter
lost_gps Percent Lost GPS %
lost_gps_5 Percent Lost GPS based on 5 Satellites %
lost_gsm Percent Lost GSM %
lost_gprs Percent Lost GPRS %
lost_pdp Percent Lost PDP %
Low Voltage Counter (# of sec < 9 Volts) Low Voltage Counter sec
high_volt_c High Voltage Counter (# of sec > 16 Volts) sec
cont_act_c Context Activation Counter
d_byte_out Data Bytes Out
ack_byte_in ACK Bytes In
dota_byte_in DOTA Bytes In
sms_out SMS Msg Out Counter
sms_in SMS Msg In Counter
sms_spam_in SMS Spam Msg In Counter
bz_state Buzzer State (if equipped in device):
0 - Buzzer OFF
1 - Buzzer Pattern 1 (slow beeps for 10 sec)
2 - Buzzer Pattern 2 (fast beeps for 10 sec)

More devices from the manufacturer