B50

0: success/ok;

1: failure;

2: incorrect information;

3: not supporting

Mileage, corresponding to the odometer reading of the car

Fuel capacity, corresponding to the fuel gaugeof the car

0: connected to the charger;

1: not connected to the charging

Battery Percentage

The mode the device is currently in

1- timer mode;

2- smart mode;

3- super power saving mode

Vehicle signal status bit

Bit0 : Low beam signal

Bit1 : High beam signal

Bit2 : Right indicator signal

Bit3 : Left indicator signal

Bit4 : Brake signal

Bit5 : Reverse signal

Bit6 : Fog light signal

Bit7 : Outline marker lamps

Bit8 : Trumpet signal

Bit9 : Air-conditioner status

Bit10 : Neutral gear signal

Bit11 : Retarder operation 34

Bit12 : ABS operation

Bit13 : Heater operation

Bit14 : Clutch status

Bit15-31 : Reserve

Strength of wireless communication network signal

Definition of alarm sign bit

Bit0 : Emergency alarm, trigger after triggering alarm switch

Bit1 : Over speed alarm The sign is maintained until the alarm condition is relieved

Bit2 : Driving alarm malfunction

Bit4 : GNSS module malfunction

Bit5 : GNSS antenna was not connected or cut

Bit6 : GNSS antenna short circuited

Bit7 : The terminal main power undervoltage

Bit8 : The terminal main power is turned off

Bit9 : Terminal LCD or display malfunction

Bit10 : TTS module malfunction

Bit11 : Camera malfunction

Bit12 : Road transport certificate IC card module malfunction

Bit13 : Over speed warning

Bit14 : Fatigue driving warning

Bit15-17 : Reserve

Bit18 : The accumulated over speed driving time of the day

Bit19 : Timeout parking

Bit20 : Enter and exit the area

Bit21 : Enter and exit the route

Bit22 : The driving time of the route is not enough/too long

Bit23 : Off track alarm

Bit24 : Vehicle VSS malfunction

Bit25 : Abnormal fuel capacity of vehicle

Bit26 : The vehicle is stolen (through vehicle burglar alarm)

Bit27 : Illegal ignition of vehicle

Bit28 : Illegal displacement of vehicle

Bit29 : Collision warning

Bit30 : Rollover warning

Bit31 : Illegal open doors alarm (when the terminal not set up, it’s not judged illegal open doors)

Definition of status bit

Bit0 - 0: ACC off; 1: ACC on

Bit1 - 0: Not positioning; 1: Positioning

Bit2 - 0: North latitude; 1: South latitude

Bit3 - 0: East longitude; 1: West longitude

Bit4 - 0: Running status; 1: Stop running status

Bit5 - 0: Latitude and longitude are not encrypted by secret plug-ins; 1: Latitude and longitude are encrypted by secret plug-ins

Bit6-7 - Reserve

Bit8-9 - 00: Empty load; 01: Half load; 02: Reserve; 3: Full load (It can be used for empty/heavy passenger car and empty/full loadstatus of the truck, manual input or sensor acquisition)

Bit10 - 0: Vehicle oil line is normal; 1: Vehicle oil line disconnect

Bit11 - 0: Vehicle circuit is normal; 1: Vehicle circuit disconnect

Bit12 - 0: Vehicle door unlocked; 1: Vehicle door locked

Bit13 - 0: Door 1 close; 1: Door 1 open (front door)

Bit14 - 0: Door 2 close; 1: Door 2 open (middle door)

Bit15 - 0: Door 3 close; 1: Door 3 open (back door)

Bit16 - 0: Door 4 close; 1: Door 4 open (door of driver’s seat) 32

Bit17 - 0: Door 5 close; 1: Door 5 open (user-defined)

Bit18 - 0: No GPS positioning; 1: GPS positioning

Bit19 - 0: No Beidou positioning; 1: Beidou positioning

Bit20 - 0: No GLONASS positioning; 1: GLONASS positioning

Bit21 - 0: No Galileo positioning; 1: Galileo positioning

Bit22-31 - Reserve

Vehicle Battery voltage

Engine speed

Vehicle speed

Throttle opening

Engine load

Coolant temperature: (-40 — 215)

Instantaneous fuel consumption

Average fuel consumption

Mileage from start engine

Total mileage

Fuel consumption from start engine

Total fuel consumption

DTC error code quality

Rapidly Accelerate times

Rapidly Decelerate times

Total time from start engine

IDL time from start engin

Advance angle of ignition

MAF

Inlet temperature: (-40 — 215)

Inlet manifold pressure

Vehicle VIN code

Battery Voltage