Equipo de videovigilancia Queclink CV100LG

Características Queclink CV100LG:

3G
4G/LTE
Caja negra

Soportado en Wialon:

Guardado de vídeos de eventos
Transmisión en directo
Guardado manual de vídeos
Reproducción de grabaciones

Para que el sistema de rastreo Wialon identifique los datos de Queclink CV100LG en el diálogo de configuración de la unidad, indique los siguientes datos :

Tipo de dispositivo:	Queclink CV100LG
ID único:	imei

Indique los siguientes parámetros en el programa de configuración o en la configuración Queclink CV100LG para utilizarlos en Wialon Hosting :

Puerto del servidor:

22197

En el centro de servicio Wialon se utilizan 264 unidades Queclink CV100LG — es 1.05% de la cantidad total de dispositivos Video monitoring conectados.

La gráfica representa la cantidad de conexiones en el centro de servicio Wialon en los últimos 30 días:

Nombre del parámetro	Descripción	Unidades de medida
dev_type	Queclink device type *HEX mode only
proto_ver	Queclink protocol version *HEX mode only
fw_ver	Firmware version *HEX mode only
battery	Battery level, 0-100
pwr_ext	External power source voltage
adc_mode	Analog Input Mode
adc1	Analog Input 1 voltage
din_status	Digital Input (bit mask)
dout_status	Digital Output (bit mask)
motion_status	17 (0x11) Ignition off Rest: The vehicle is ignition off and motionless. 18 (0x12) Ignition off Motion: The vehicle had been moving before this action was regarded as car-towing event after ignition off. 33 (0x21) Ignition On Rest: The vehicle is ignition on and motionless. 34 (0x22) Ignition On Motion: The device is ignition on and moving.
phone_number
ign_dur
ibutton
ibutton_auth
geo_id
ges_enabled
ges_mode
ges_radius
ges_dt
geo_area_type
geo_mask_group
geo_area_mask_group_1
geo_area_mask_group_2
jamming_cw
jamming_gps
upc_cmd_id
upc_result
url
x_forward
y_forward
z_forward
x_side
y_side
z_side
x_vert
y_vert
z_vert
onewire[i]_id
onewire[i]_type
onewire[i]_data
fuel_sensor[i]_type
fuel_sensor[i]_id
fuel_sensor[i]_percent
fuel_sensor[i]_volume
pwr_int
jamming_status
crash_counter
upd_code
upd_retry
idle_dt
gps_signal_status
wave1_out_id
wave1_out_active
temp_alarm_id
temp_status
temp_device_id
temp_device_data
roaming_state
curr_mileage	Current Trip Mileage *HEX mode only
total_mileage	Total Mileage *HEX mode only
curr_hourmetercount	Current Trip Hour Meter Count (accumulative ignition time) *HEX mode only
total_hourmetercount	Total Hour Meter Count (accumulative ignition time) *HEX mode only
hw_ver
mcu_ver
fri_discard_no_fix
resp_report_mask
ign_dt
igf_dt
bat_status
iccid
csq_ber	CSQ BER,0-7/99
daylight_saving
time_zone
tcp_cmd_count
udp_cmd_count
sms_cmd_count_white
sms_cmd_count
tcp_msg_count
udp_msg_count
sms_msg_count_white
sms_msg_count
gir_trigger
mnc[i]
lac[i]
cell_id[i]
ta[i]
rx_level[i]
gps_level
jamming_indicator
sat_[sv_id]
local_ip
ledon	1 - Cell LED anf GNSS LED turn on as configured 2 - Both LEDs work 10 minutes after tge device is powered on and then will be off.
charging	Wheter the backup battery is charging when the main power supply is connected
pwr_s	whether the external power supply is connected.
csq_rssi	the level of signal strength
id	The ID which is currently read
id_reptype	The ID is unauthorized or the ID authorization (IDA) function is disabled; The ID is authorized
indx	The index of Bluetooth accessory defined in AT+GTBAS which triggers the +RESP:GTBAA message 0xFF for WKF300
acces_type	0 - No bluetooth accessory 1 - Reserved 2 - Beacon temperature sensor 3 - BLE beacon ID device
acbe_model	The model of the bluetooth accessory
alarm_type	0 - the voltage of the Bluetooth accessory is low 1 - the temperature alarm: current temperature value is below 2 - the temperature alarm: current temperature value is upper 3 - the temperature alarm: current temperature value is within the range defined by <low temperature> and <high temperature> 4 - Push button event on WKF300 is detected
bt_name	Bluetooth accessory name
bt_mac	Bluetooth accessory mac
bt_status	0 - the accessory is not available 1 - the accessory is available
bt_bat_level	The voltage of Bluetooth accessory
bt_temp	Temperature data fo Bluetooth accessory
can_eng_torgue	Engine Torgue
event_id	Events of driver safety system (ADAS and DMS). Reports in GTDSS packet with the following values: 1 - Eye Close 2 - Yawling 3 - Distraction 4 - Smoking 5 - Phone Use 6 - Drive abnormal 7 - IR blocking 8 - Seatbelt unfastened 20 - Forward collision warning 21 - Pedestrian collision warning 22 - Headway monitoring warning