| cam_num |
Total number of cameras that this
device supports |
|
| cam_status |
Bitwise parameter of cameras connected status.
bit1 - 1 indicates Camera 1 is connected;
0 indicates Camera 1 is disconnected;
...
bit64 - indicates Camera 64 status
|
|
| time_start |
Start time
|
|
| time_end |
End time
|
|
| alarm_flag8 |
Alert event code Bytes 0–5: reserved Bytes 6–7: Correspond to Meitrack's event codes, big-endian
|
|
| av_type |
Audio and video resource type 0: Audio and video 1: Audio 2: Video 3: Video, or audio and video
|
|
| stream_type |
Bitrate type 0: All streams 1: Major stream 2: Minor stream
|
|
| cap_type |
Memory type 0: All memories 1: Active memory 2: Standby memory
|
|
| file_length |
File size. Unit: byte, big-endian
|
|
| video_uri |
Video URI
|
|
| video_type |
Video type
|
|
| ftp_upload_percent |
Uploading progress percentage. Value
range: 0–100.
|
|
| ftp_filename |
File name
|
|
| RFID |
RFID code |
|
| event_code |
Event Code | Event number | Event description | | 1 | SOS Pressed | | 2 | Input 2 Active | | 3 | Input 3 Active | | 4 | Input 4 Active | | 5 | Input 5 Active | | 6 | Input 6 Active | | 7 | Input 7 Active | | 8 | Input 8 Active | | 9 | Input 1 Inactive | | 10 | Input 2 Inactive | | 11 | Input 3 Inactive | | 12 | Input 4 Inactive | | 13 | Input 5 Inactive | | 14 | Input 6 Inactive | | 15 | Input 7 Inactive | | 16 | Input 8 Inactive | | 18 | Low External Battery | | 19 | Speeding | | 20 | Enter Geo-fence | | 21 | Exit Geo-fence | | 22 | External Battery On | | 23 | External Battery Cut | | 24 | GPS Signal Lost | | 25 | GPS Signal Recovery | | 26 | Enter Sleep | | 27 | Exit Sleep | | 28 | GPS Antenna Cut | | 29 | Device Reboot | | 31 | Heartbeat | | 32 | Cornering | | 33 | Track By Distance | | 34 | Reply Current(Passive) | | 35 | Track By Time Interval | | 36 | Tow | | 37 | RFID | | 41 | Stop moving | | 42 | Start moving | | 50 | Temperature High | | 51 | Temperature Low | | 52 | Full Fuel | | 53 | Low Fuel | | 54 | Fuel Theft | | 70 | Reject Incoming Call | | 71 | Get Location by Call | | 72 | Auto Answer Incoming Call | | 78 | EEP2_MDVR_EVENT_IMPACT | | 82 | Fuel Filling | | 83 | Ult-Sensor Drop | | 87 | 18519 | | 90 | Sharp Turn to Left | | 91 | Sharp Turn to Right | | 94 | Output 1 Active | | 95 | Output 2 Active | | 96 | Output 3 Active | | 97 | Output 4 Active | | 98 | Output 5 Active | | 99 | Output 1 Inactive | | 100 | Output 2 Inactive | | 101 | Output 3 Inactive | | 102 | Output 4 Inactive | | 103 | Output 5 Inactive | | 117 | People Counter | | 129 | Harsh Braking | | 130 | Harsh acceleration | | 133 | Idle Overtime | | 134 | Idle Recovery(Recovery from Idle Overtime) | | 135 | Fatigue Driving | | 136 | Enough Rest after Fatigue Driving | | 138 | Speed Recovery | | 139 | Maintenance Notice | | 159 | Out6 Active | | 160 | Out7 Active | | 161 | Out8 Active | | 162 | Out6 Inactive | | 163 | Out7 Inactive | | 164 | Out8 Inactive | | 576 | CH1 Video Loss | | 577 | CH2 Video Loss | | 578 | CH3 Video Loss | | 579 | CH4 Video Loss | | 580 | CH5 Video Loss | | 581 | CH6 Video Loss | | 608 | Storage Error | | 609 | Full Storage | | 610 | CH1 Video Recovery | | 611 | CH2 Video Recovery | | 612 | CH3 Video Recovery | | 613 | CH4 Video Recovery | | 614 | CH5 Video Recovery | | 615 | CH6 Video Recovery | | 648 | Forward-CW | | 650 | Pedestrian-CW | | 651 | Left-LDW | | 652 | Right-LDW | | 653 | HMW(Distance) | | 655 | DMS_CALL | | 656 | DMS_SMOKING | | 657 | DMS_TIRED | | 658 | DMS_YAWN | | 659 | DMS_DISTRACT | | 660 | DMS_LOSE | | 661 | DMS_COVERED | | 662 | DMS_IR_BLOCK | | 663 | DMS_SEATBELT | | 669 | BSD_FRONT | | 670 | BSD_BEHIND | | 671 | BSD_LEFT | | 672 | BSD_RIGHT |
|
|
| gps_valid |
GPS status |
|
| gsm_signal |
GSM signal |
|
| hdop |
Horizontal Dilution of Precision |
|
| mileage |
Total accumulated mileage |
km |
| run_time |
Total accumulated runtime |
|
| battery |
battery charge |
% |
| adc5 |
Voltage of external power supply * 100
|
V |
| fuel_percent |
Percentage of remain fuel |
% |
| temp_N |
Temperature sensor N value |
°C |
| wln_accel_max |
Maximum acceleration value |
g |
| wln_brk_max |
Maximum deceleration value |
g |
| lls_N_temp |
LLS fuel sensor N temperature
|
°C |
| lls_N_val |
LLS fuel sensor value
|
|
| lls_N_freq |
LLS fuel sensor frequency
|
|
| dr_f_status |
Driver fatigue alert:
- 01 - Mild fatigue
- 02 - Moderate fatigue
- 03 - Severe fatigue
- 04 - Distraction alert
- 05 - Absence alert
- 06 - On Phone Call alert
- 07 - Smoking alert
- 08 - Yawning alert
|
|
| mccN |
Mobile country code for SIM card in slot N
|
|
| mncN |
Mobile network code for SIM card in slot N
|
|
| lacN |
Local area code for SIM card in slot N
|
|
| cell_idN |
Cellular station identification for SIM card in slot N
|
|
| outputs_status |
Output status
|
|
| inputs_status |
Bits 0–31 correspond to status of input ports 1–31
|
|
| system_flag |
The data is available only when the GPRS event code is 35. Bit 0: Whether to modify the EEP2 parameter. When the parameter value is 1, the EEP2 parameter is modified.
Bit 1: Indicates the ACC status. When the parameter value is 1, the ACC is on.
Bit 2: Indicates the anti-theft status. When the parameter value is 1, the tracker is in the arming state.
Bit 3: Reserved.
Bit 4: Moving flag. When the parameter value is 1, the tracker is moving.
Bit 5: Whether to connect the external power
supply. When the parameter value is 1, the external power supply is connected.
Bit 6: Whether the tracker is charging. When the parameter value is 1, the tracker is charging.
Bit 7: Whether to enable the sleep mode. When the parameter value is 1, the sleep mode is enabled.
Bit 8: Whether to connect the FMS. When the parameter value is 1, the FMS is connected.
Bit 9: Whether to enable the FMS function. When the parameter value is 1, the function is enabled.
|
|
| netw_ver |
The version of the network being connected， 0x01 by default
|
|
| netw_type |
The type of network being connected， 0: No Network,
1: Mobile Network,
2:WIFI (Reserved),
3: LAN (Reserved)
|
|
| adc1-3 |
Analog input value * 100
|
V |
| adc4 |
Battery analog *100
|
V |
