Queclink GL300VC

Queclink GL300VC
Rating del usuario

(4 Votos)

Cantidad de unidades

25
En línea
478
Total
Características Queclink GL300VC:
  • Caja negra
Soportado en Wialon:
  • Manejo remote via GPRS
  • LBS
  • Manejo remote via SMS
  • Comunicación por TCP
  • Comunicación por UDP

Para que el sistema de rastreo Wialon identifique los datos de Queclink GL300VC en el diálogo de configuración de la unidad, indique los siguientes datos:

Tipo de dispositivo: Queclink GL300VC
ID único: imei

Indique los siguientes parámetros en el programa de configuración o en la configuración Queclink GL300VC para utilizarlos en Wialon Hosting:

Dirección IP del servidor: 193.193.165.165
Puerto del servidor: 21054

En el centro de servicio Wialon se utilizan 478 unidades Queclink GL300VC — es 0.09% de la cantidad total de dispositivos Automóvil conectados.

La gráfica representa la cantidad de conexiones en el centro de servicio Wialon en los últimos 30 días:

Nombre del parámetro Descripción Unidades de medida
battery Battery level %
charging Whether the battery is charging when the external power supply is connected:
0: Not charging
1: Charging
external_pwr External power supply:
0: Not connected
1: Connected
gps_antenna_type A numeric to indicate which GPS antenna is working now
0: inside GPS antenna
gps_on_need Whether to close GPS chip after retrieving GPS position information:
0: Never close GPS chip
1: Close GPS chip after retrieving GPS information every time
2: Never close GPS chip only in ignition on state or movement state
3: Never open GPS chip
gsm_level The GSM signal strength level
gsm_quality The quality of GSM signal
hdop Horizontal Dilution of Precision
ign Ignition state: 0: off, 1: on
ign_off_duration Duration since last time the ignition is off s
ign_on_duration Duration since last time the ignition is on s
led_on The working mode of LEDs
mileage The total mileage km
movement_cause The enter movement cause defines the factor who triggers the message:
0: Triggered by motion sensor detection. It is defaulted
1: Triggered by RTO sub command RTL
2: Triggered by the command GTLSW from EBK
movement_state 0: The state of the device changed from motion to rest
1: The state of the device changed from rest to motion
odo_mileage The total mileage in the position km
pwr_int Battery voltage V
report_type Message type
state The current motion state of the device:
21: The device attached vehicle is ignition on and motionless
22: The device attached vehicle is ignition on and moving
41: The device is motionless without ignition on
42: The device is moving without ignition on
temp_int The temperature of the device °C

Otros dispositivos del fabricante