| battery |
The current volume of the backup battery |
|
| call_number |
The phone number of the incoming call |
|
| charging |
Whether the backup battery is charging when the main
power supply is connected.
0 - not charging
1 - charging |
|
| csq_ber |
The quality of the GSM signal. The range is 0-99 |
|
| curr_hour_meter |
The current hour meter count |
|
| curr_mileage |
The current mileage |
|
| data_type |
The data reported to backend server is recorded before
or after crash:
0 - before crash
1 - after crash |
|
| AGPS |
Support AGPS |
|
| Engine Stop |
Can connect relay to stop car’s engine |
|
| MIC |
Inner Mic-phone for voice monitor |
|
| SOS |
SOS button |
|
| Bluetooth |
Bluetooth for 2 ways audio |
|
| ext_pow_supply |
Whether the external power supply is connected.
0 - not connected
1 - connected |
|
| fuel_level_input |
Indicates the nominal fuel tank liquid fill capacity
as a percent of maximum |
|
| gps_acc |
GPS accuracy |
|
| gps_signal |
GPS signal status:
0 - lost GPS signal or no successful GPS fix
1 - GPS signal recovered and successful GPS fix |
|
| hard_ver |
The hardware version |
|
| harsh_behavior |
Harsh behavior |
|
| harsh_speed_level |
The speed level of which the harsh behavior is
detected |
|
| idling |
The time that the vehicle has been in idling status |
|
| ign_off_duration |
Duration since last time the ignition is off |
|
| ign_on_duration |
Duration since last time the ignition is on |
|
| jamming_status |
The current Jamming status of the device.
1 - quit the jamming
2 - enter the jamming |
|
| led_on |
Whether the LED’s are turned on.
0 - off
1 - on |
|
| mil_activated_dist |
The distance accumulated since MIL is activated |
|
| mileage |
The total mileage |
|
| mil_status |
Malfunction Indicator Lamp (MIL) status:
0 - off
1 - on |
|
| packet_type |
Report packet type |
|
| pwr_ext |
The voltage of the external power supply |
|
| pwr_int |
The voltage of the backup battery. The value of this
field is only valid when the external power is not connected. |
|
| soft_ver |
The software version |
|
| state |
The current motion state of device:
- Tow
- Fake Tow
- Ignition Off Rest
- Ignition Off Motion
- Ignition On Rest
- Ignition On Motion
- Sensor Rest
- Sensor Motion
|
|
| throttle_pos |
Indicates a percentage of throttle position sensor
value. Usually above 0% at idle and less than 100% at full
throttle. |
|
| time_zone |
Time zone offset |
|
| x_axisN |
The X axis acceleration |
|
| y_axisN |
The Y axis acceleration |
|
| z_axisN |
The Z axis acceleration |
|
| ble_#_light_box |
Ble light sign bit (# - ble sensor id) 1- light on, 0 - light off |
|
| ble_#_light |
Ble, Value of light intensity, (# - ble sensor id) |
|
| ble_data_code |
Ble data code 1 - The BLE tire pressure sensor data code 2 - The BLE SOS data code 3 - The BLE driver identification data code 4 - The BLE Temperature and humidity sensor data code 5 - The BLE door sensor data code 6 - The BLE RELAY data code 7 - The BLE Fuel Level Sensor data code 10 - The FH Analog sensor data code 11 - The MiTag Temperature and humidity sensor data code 12 - The ELA sensor pass-through data code |
|
| tps_#_pwr_int |
Ble tps battery voltage, # -ble sensor id |
|
| tps_#_air_pres |
Ble tps air pressure, # - ble sensor id |
|
| tps_#_air_temp |
Ble tps air temperature, # -ble sensor id |
|
| tps_#_status |
Ble tps status, # - ble sensor id |
|
| ble_tag_id |
Ble tag id |
|
| ble_#_battery |
Ble tag battery voltage, # - ble tag id |
|
| ble_#_sos_type |
Ble sos data type, # -ble tag id |
|
| ble_#_gnss_status |
Ble tag gnss status, #- ble tag id |
|
| ble_#_driver_ident_type |
Ble driver identification type, # - ble tag id |
|
| ble_sens_id |
Ble sensor id |
|
| ble_#_pwr |
Ble battery voltage, # - ble sensor id |
V |
| ble_#_pwr_p |
Ble battery percantage, # - ble sensor id |
|
| ble_#_temp |
Ble temperature, # - ble sensor id |
|
| ble_#_hmdt |
Ble humidity, # - ble sensor id |
|
| ble_#_rssi |
Ble rssi, # - ble sensor id |
dBm |
| mcu_model |
MCU model |
|
| mcu_fw_ver |
MCU firmware version |
|
| modem_ver |
Modem version |
|
| modem_app |
Modem app version |
|
| hw_ver |
Hardware version |
|
| gnss_status |
Data and GNSS status (Bits 1-8) 1. Bit8=0, realtime data; Bit8=1, history data
2. Bit7=0, LBS data; Bit7=1, GNSS data
3. Bit6=0, GNSS is in working mode. Bit6=1,GNSS is in sleeping mode
4. Bit5-Bit1, locked satellite count
|
|
| alarm |
Alarm code |
|
| acc_z |
Acceleration Value |
g |
| acc_y |
Acceleration Value |
g |
| acc_x |
Acceleration Value |
g |
| battery_percent |
Build in Battery Voltage (%) |
|
| temp |
Device Internal Temperature (℃) |
|
| front_light |
Front Light Sensor Voltage |
V |
| solar_voltage |
Solar Panel Voltage |
V |
| odom |
Odometer (Meter) |
|
| status |
Status (Bits 1-16) 1. Bit16= 1, USB cable connected(with power), Bit16 =0, USB cable disconnected(without power) 2. Bit15~Bit12 show 4 manager phone number set or not. (1=set, 0=not) 4. Bit 11~Bit5, Network signal strength. Range: 0~100
5. Bit4=1, solar panel is charging the battery, Bit4=0, solar panel doesn't charge the battery 6. Bit3=1, ignition on (moving), Bit3=0, ignition off (standstill) 7. Bit2=1 (Xtra Yes), Bit2=0 (Xtra No) 8. Bit1=0, normal timer reporting (TLP1-LF, TLP1-SF & TLP1-P), Bit1=1, smartpower timer reporting (TLP1-LF, TLP1-SF & TLP1-P) |
|
| acc_on |
Igniton ON Upload Interval(Second) |
|
| acc_off |
Ignition OFF or Accdet=0 Upload Interval (Second) |
|
| angle |
Angle Upload Interval (Degree) |
|
| distance |
Distance Upload Interval (Meter) |
|
| heart |
Heartbeat (Minute) |
|
| settings_status |
Current Setting Status Informaiton(1) (Bits 1-8) 1. Bit8: lock SIM card setting status, Bit8=1, locked, Bit8=0, unlocked 2. Bit7: lock device setting status, Bit7=1, locked, Bit7=0, unlocked 3. Bit6: AGPS Ephemeris data download setting status, Bit6=1, enable download, Bit6=0, disable download 4. Bit5:G-sensor setting status, Bit5=1 enable, Bit5=0, disable 5. Bit4: front sensor setting status, Bit4=1, enable, Bit4=0, disable 7. Bit2: open case alarm setting status,Bit2=1, enable, Bit2=0, disable 8.Bit1: device internal temperature reading and uploading setting status, Bit1=1, enable, Bit1=0, disable |
|
| network_operator |
Network Operators Name |
|
| access_name |
Access Technology Name |
|
| band_name |
Band Name |
|
| imsi |
SIM Card IMSI |
|
| iccid |
ICCID |
|
| ign |
ACC status, 0 - ACC ON, 1 - ACC OFF |
|
| mnc |
Mobile Network Code |
|
| mcc |
Mobile Country Code |
|
| lac |
Location Area Code |
|
| cell_id |
Cell Tower ID |
|
| network_signal |
Network signal strength. Range: 0~100 |
|
