Number of units
The following data should also be added to Wetrack 140 unit properties section of Wialon GPS tracking software :
| Device type: | Wetrack 140 |
| Unique ID: | imei |
Specify the following parameters in configuration software or configuration Wetrack 140 for use in Wialon Hosting :
| Server port: | 21934 |
40 units of Wetrack 140 device type are connected to Wialon Data Center. This represents 0% of all AVL Hardware connected.
Below chart represents the dynamic of connections in the last 30 days:
| Parameter name | Description | Units |
|---|---|---|
| vendor_id | Vendor identification header | |
| vehicle_reg_num | Mapped vehicle registration number |
|
| fw_version | Indicates Firmware Version running in the device |
|
| prot_version | Communication protocol identifier |
|
| packet_type | Packet type | |
| packet_status | Packet status | |
| mess_id | Message ID | |
| gps_fix | 1 = GPS fix Valid |
|
| pdop | Positional dilution of precision | |
| hdop | Horizontal dilution of precision | |
| operator_name | Name of network operator | |
| ign | Ignition status | |
| battery_status | 0=Vehicle Battery disconnected |
|
| pwr_ext | Main input voltage |
V |
| pwr_int | Internal battery voltage |
V |
| emergency_status | Emergency status |
|
| tamper_alert | Tamper Alert: |
|
| frame_num | Sequence number of the messages |
|
| delta_distance | Distance in meters | |
| bat_percent | Indication for the internal battery charge in percentage |
% |
| low_bat_percent | Indication for the low battery alert generated in percentage |
% |
| memory_percent# | Indicates flash memory used by server # in percentage |
% |
| ign_on_interval | Ignition ON Interval time in seconds |
sec |
| ign_off_interval | Ignition OFF Interval time in seconds |
sec |
| distance | Distance calculated from previous GPS data in meters |
m |
| provider | G - Fine GPS |
|
| reply_num | The mobile number to which test response needs to be sent. |
