Starlink GLONASS

Starlink GLONASS
Forum Discussion
Discontinued

Number of units

0
Online
0
Total

The following data should also be added to Starlink GLONASS unit properties section of Wialon GPS tracking software :

Device type: Starlink GLONASS
Unique ID: serial

Specify the following parameters in configuration software or configuration Starlink GLONASS for use in Wialon Hosting :

Server port: 20581

0 units of Starlink GLONASS device type are connected to Wialon Data Center. This represents 0% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name Description Units
alarm_armed Shows if alarm is armed. 0 - disarmed, 1 - armed
alarm_door Door state. 0 - closed, 1 - open
alarm_hood Hood state. 0 - closed, 1 - open
can_fuel_level CAN fuel level %
can_odometer CAN odometer value
can_rpm CAN engine revolutions per minute value r/min
can_speed CAN speed value km/h
can Value 1 shows that message contains CAN data
engine Engine. 0 - off, 1 - on
event_id Code of the event
ign Ignition state. 0 - off, 1 - on
immobilizer_armed Immobilizer state
in_port_e Input 3 / Port E value. 0 - off, 1 - on
in_port_f Input 4 / Port F value. 0 - off, 1 - on
odometer Odometer value m
out_port_b Output 2 / Port B value. 0 - off, 1 - on
pwr_ext Backup battery voltage V
pwr_int Vehicle battery voltage V
ref_num Message number
esafe_msg_type

Message type from eSafe:
137 - Maneuver notification, will be transmitted as Drive rule occurred if enabled
143 - Accident notification, will be transmitted as Accident detected if enabled
144 - Drive status changed
145 - Too many events
146 - Bad installation
147 - Possible accident notification

esafe_maneuv_type

The eSafe maneuver type:
1 - Acceleration
2 - Breaking
3 - Left turn
4 - Right turn
5 - Wide left turn
6 - Wide right turn
7 - Left turn while decelerating
8 - Left turn while accelerating
9 - Wide left turn while decelerating
10 - Wide left turn while accelerating
11 - Right turn while decelerating
12 - Right turn while accelerating
13 - Wide right turn while decelerating
14 - Wide right turn while accelerating
15 - Traffic circle
16 - Lane change
17 - Overtaking
18 - Speed bump
19 - Start of off-road driving
20 - End of off-road driving

esafe_maneuv_level

The eSafe maneuver level:
1 - Low
2 - Medium
3 - High

esafe_maneuv_dur The eSafe maneuver duration ms
esafe_force_x The eSafe maximum g force detected in the X axis g
esafe_force_y The eSafe maximum g force detected in the Y axis g
esafe_force_z The eSafe maximum g force detected in the Z axis g
esafe_accident_direct

The eSafe accident directions:
1 - Front
2 - Front left
3 - Front right
4 - Back
5 - Back left
6 - Back right
7 - Left
8 - Right
9 - Vehicle rolled over

esafe_driver_state

The eSafe driver state:
0 - Normal
1 - Aggressive
2 - Dangerous

esafe_aggres_maneuvers The eSafe total number of aggressive maneuvers
esafe_danger_maneuvers The eSafe total number of dangerous maneuvers
esafe_num_maneuvers The eSafe total number of maneuvers

You can also download an example of object configuration file for Starlink GLONASS to be used in Wialon GPS tracking software. When creating an object, import this configuration file by selecting "Import from File" option. This way you will create a pre-configured object with some sensors. Do not forget to specify the unique Id of Your device.

More devices from the manufacturer

Contact Wialon and achieve the most ambitious goals with telematics

Fill out a request form to get started with Wialon

Step 1
Step 2
Step 3
First and last name*
Company*
Email*
Phone