Kingwo MT Series

Kingwo MT Series
Manufacturer: Kingwo
Forum Discussion

Number of units

Features Kingwo MT Series:
  • Blackbox
  • Wi-Fi positioning
Supported in Wialon:
  • Remote management via GPRS
  • LBS
  • Communication via TCP

The following data should also be added to Kingwo MT Series unit properties section of Wialon GPS tracking software:

Device type: Kingwo MT Series
Unique ID: serial

Specify the following parameters in configuration software or configuration Kingwo MT Series for use in Wialon Hosting:

Server port: 21724

162 units of Kingwo MT Series device type are connected to Wialon Data Center. This represents 0.01% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name Description Units
stN Status of byte N.
  • bit1 - Lock. Applicable to MT01/MT02S
  • bit2 - GPS module error
  • bit0 - acc on
st2 & st3 & st4 are reserved
alN Alarm of byte N.
  • bit2 - vibration alarm. Applicable to MT01/MT02S
  • bit3 - movement alarm. Applicable to MT01/MT02S
  • bit2 - speeding alarm. Applicable to the wired terminals
  • bit1 - cable cut off alarm. Applicable to MT01/MT02S
  • bit2 - low voltage alarm of the main power. Applicable to the wired terminals
al2 & al4 are reserved
mileage Mileage km
pwr_ext Main power voltage V
speed_sens Additional info about speed nmi/h
gsm GSM signal strength
al_expN Additional info about extended status:
  • bit0 - blind area compensation data
  • bit1 - in sleep mode. Applicable to wired terminals
  • bit2 - removal status. Applicable to wireless terminals
  • bit3 - RTC Error. Applicable to wireless terminals
  • bit0 - track mode. Applicable to wireless terminals
  • bit1 - G-sensor error. Applicable to wired terminals
  • bit2 - Improper installation, anti-removal button or light sensor terminal installation error. Applicable to wireless terminals
  • bit1bit0 - 01 - power off restart. 11 - software reset. 00 - other reset
  • bit0 - communication interrupted
  • bit3 - WIFI module error. Applicable to wireless WIFI terminal
al_exp4 is reserved
mcc Mobile country code
mnc Mobile network code
lac Location area code
cell_id Cell ID
blind_area Blind area data
  • bit0 - Network register failure
  • bit1 - PDP activation context failed
  • bit2 - IP error. Unable to connect to the server
  • bit3 - domain name error. Unable to connect to the server
  • bit9 - module error
  • bit10 - SIM card error
  • bit11 - device ID error
  • bit16 - upgrading. Applicable to the wired terminals
  • bit24 - communication interrupted
  • bit25 - no signal
term_params Terminal parameters
bat_lvl Remaining battery capacity percentage %

Fill out a request form to get started with Wialon

Step 1
Step 2
Step 3
First and last name*