Number of units

Supported in Wialon:
  • Camera connection
  • Communication via TCP

The following data should also be added to JC100 unit properties section of Wialon GPS tracking software:

Device type: JC100
Unique ID: imei

Specify the following parameters in configuration software or configuration JC100 for use in Wialon Hosting:

Server port: 21607

22 units of JC100 device type are connected to Wialon Data Center. This represents 0% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name Description Units
alarm_type Alarm Type:
1: SOS alarm
9:displacement alarm
128: vibration alarm
129:Excess data traffic alarm
130:Device reboot
131:collision alarm
132: forward camera abnormal
133: inward camera abnormal
134:SD card can’t be identified
135:overspeed alarm
136:power off alarm
137: no inward camera
138:Enable power/oil cutoff alarm
139:Disable power/oil cutoff alarm
144: harsh acceleration alarm
145: harsh deceleration alarm
146:sharp turn alarm
147: collision alarm
mcc Mobile Country Code
mnc Mobile Network Code
lac Location Area Code
cell_id Cell Tower ID
voltage_lvl The range is 0~6 defining the voltage is from low to high.
0: No Power (shutdown)
1: Extremely Low Battery
2: Very Low Battery
3: Low Battery
4: Medium
5: High
6: Very High
gsm GSM Signal Strength Levels
0: no signal;
1: extremely weak signal;
2: very weak signal;
3: good signal;
4: strong signal.
tr_status Bitmask representing different terminal statuses.
1:Oil/Electricity cutoff
0:Oil/Electricity on
0: GPS tracking is off
1: GPS tracking is on
Extended bit
0: Charge Off
1: Charge On
1: ACC high
0: ACC Low
0: Disarm
acc 1: ACC high
0: ACC Low
up_mode Data Upload Mode:
(could be only one mode available)
0 upload by time interval
1 upload by distance
2 upload for corner correction
3 upload by ACC status change
4 Re-upload last valid locating point after shift from dynamic motion to static position
5 Report last valid locating point after network reconnected.
6 Update the ephemeris to upload locating point.
7 Press to upload locating point
8 Power on to upload locating point
9 Power on and change locating point by GPS based station.

Photo and video (up to 20 seconds) request is available

More devices from the manufacturer