GNX-3

GNX-3
Forum Discussion

Number of units

0
Online
50
Total
Features GNX-3:
  • 4G/LTE
  • Blackbox
  • Built-in odometer
Supported in Wialon:
  • CAN-bus support
  • Garmin support
  • Remote management via GPRS
  • Driver identification
  • Digital sensors
  • Communication via UDP

The following data should also be added to GNX-3 unit properties section of Wialon GPS tracking software :

Device type: GNX-3
Unique ID: serial

Specify the following parameters in configuration software or configuration GNX-3 for use in Wialon Hosting :

Server port: 21383

50 units of GNX-3 device type are connected to Wialon Data Center. This represents 0% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name Description Units
avg_speed Speed average used for state determination km/h
calls_supported Current services supported by the cellular modem
delta_odometer Delta odometer from prior event m
ext_adc External A2D convertor input voltage. May be used for peripherals such as temperature sensor V
ext_temp_1 Temperature of external probe connected to input #1 of Sensatronics IT temperature model F RS232 convertor °C
ext_temp_2 Temperature of external probe connected to input #2 of Sensatronics IT temperature model F RS232 convertor °C
fw_vers Firmware version
iccid The ICCID of the modem SIM card
idle_time Duration of idling (speed < STOP_SPEED and ignition on) min
ign Ignition state
landmark_bearing Bearing from above landmark °
landmark_dist Distance from above landmark km
landmark Name of closest landmark, if one is defined
odometer GNX odometer km
pdop PDOP (Position Dilution of Precision)
phone_number The phone number of the cellular modem (or SIM card)
pwr_supply GNX primary power supply voltage level V
reason_code The reason that caused the GNX to queue this event (number)
reason The reason that caused the GNX to queue this event (text)
region Name of region (boundary) in which the GNX is located
rssi Current received signal strength of the cellular modem dBm
sec_cnt Linear second count of the number of seconds since the GNX last powered on
serial_num 12 digit GenX Mobile assigned serial number. A unique identifier for a GNX
sid Current serving system identifier of the cellular modem
state MOVING, IDLING, or PARKED, based on parameters STOP_SPEED, MOVE_SPEED, STOP_TIMER, MOVE_TIMER, and the ignition input
stop_dur Stop duration min
switch_N Current state of switch input (ON/OFF). N - number of input
temp Internal GNX temperature °C
unique_id Integer that increments with each position sent, to allow unique identification of each position
wire_ext_tempN External 1 wire temperature sensor value °C or °F (depends on the 1 Wire configuration)
bt_status Status of Bluetooth connection

Please, note: if the serial number of your devices starts with zeros, you should enter Wialon unit ID without these symbols.

For example, serial number 0000123456 should be entered as 123456.

More devices from the manufacturer

Contact Wialon and achieve the most ambitious goals with telematics

Fill out a request form to get started with Wialon

Step 1
Step 2
Step 3
First and last name*
Company*
Email*
Phone