CelloTrack Nano

Manufacturer: Pointer Telocation

Forum Discussion

Number of units

Online

112

Total

Information
Parameters

Features CelloTrack Nano:

Blackbox

Supported in Wialon:

Remote management via GPRS
SMS sending of data
Communication via TCP

The following data should also be added to CelloTrack Nano unit properties section of Wialon GPS tracking software :

Device type:	Cello Track Nano20
Unique ID:	serial
Password to access the object:	Configuration password to access the object

Specify the following parameters in configuration software or configuration CelloTrack Nano for use in Wialon Hosting :

Server port:

21022

112 units of CelloTrack Nano device type are connected to Wialon Data Center. This represents 0.01% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name	Description	Units
mod28_entries	Module 28: Number of entries
mod28_e_category	Module 28: Event Category (2 Bytes)
mod28_e_code	Module 28: Event Code (2 Bytes)
mod28_sc_event	Module 28: Source of event
mod28_oc_state	Module 28: Open/Close state. (0 = Close, 1 = Open)
mod40_event_cat	Event Category – 1 (Nano)
mod40_event_code	Event Code – 1 (Temperature measurements) Event Code – 2 (Humidity measurements)
mod40_meta_reason	Metadata TX Reason: 0 – Normal 1 – Start Charging 2 – Requested by Command
mod40_alert_status	Violation/Alert status. 0 – Within the limits 1 – Within the limits 2 – Violating (not in alert) a lower TH but alert is not yet declared 3 – Violating (not in alert) a upper TH but alert is not yet declared 4 – Alert for lower TH violation 5 – Alert for upper TH violation 6 – Violating while in alert the lower TH 7 – Violating while in alert the upper TH
mod40_retr_indication	Retransmission indication. 0 – Retransmission 1 – Not retransmission
mod40_charging_status	Charging Status. 0 – Not charging* 1 – Charging slow 2 – Charging fast 3 – Charger Fault/Charger thermal shutdown
mod40_after_charging	30 min after charging indication. 0 – Not during 30 minutes after charging* 1 – During 30 minutes after charging
mod40_meta_source	Source of measurement 0x00÷0x0F – MultiSense unit (according to place in the PL, whether occupied/enabled or not) 0xFB – BT Extender 0xFC – Guest MultiSense (not in the list) 0xFD – High accuracy or specialized sensors of the CelloTrack Nano 20 (for example: Accurate temperature sensor, pressure sensor, etc) 0xFE – MCU internal (temperature only) 0xFF – Reserved
mod40_meta_sample	Metadata Sampling rate (Seconds)
mod40_{upper/lower}_{hum/temp}_{mod40_meta_source}	Metadata Upper/Lower threshold
mod40_num_sample	Number of samples in the payload
mod40_{part_name}_{mod40_meta_source}	Humidity/Temperature reading