ToTarget GPS-ELOCK

ToTarget GPS-ELOCK
Manufacturer: Totarget
Forum Discussion

Number of units

1
Online
4
Total
Dynamic hosting units ToTarget GPS-ELOCK
Supported in Wialon:
  • Remote management via GPRS
  • Remote management via SMS
  • Communication via TCP

The following data should also be added to ToTarget GPS-ELOCK unit properties section of Wialon GPS tracking software:

Device type: ToTarget GPS-ELOCK
Unique ID: serial

Specify the following parameters in configuration software or configuration ToTarget GPS-ELOCK for use in Wialon Hosting:

Server port: 21691

4 units of ToTarget GPS-ELOCK device type are connected to Wialon Data Center. This represents 0.02% of all Asset trackers connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name Description Units
drvr_num Driver number
loc_st Location status:
  • 0 - Invalid location
  • 2 - 2D location
  • 3 - 3D location
ant_st GPS antenna status:
  • 0 - Antenna is good
  • 1 - Antenna is broken
  • 2 - Antenna short
  • 3 - Mismatch antenna
mileage Cumulative mileage km
veh_st Vehicle status:
  • bit4 - Loaded
  • bit9 - No GPRS network
  • bit13 - Weak network signal
  • bit16 - Only by SMS
  • bit17 - Need encryption by PIN code
  • bit18 - GPS shutdown status
  • bit20 - Lock rod opened
  • bit21 - Lock rod broken
  • bit22 - Lock shell opened
alarm_st Alarm status:
  • bit0 - Rob alarm
  • bit1 - Steal alarm
  • bit2 - Lock rod opened alarm
  • bit3 - Low Battery alarm
  • bit4 - Shell opened alarm
  • bit5 - Lock rod broken alarm
  • bit7 - Lock motor close
  • bit9 - Over-speed alarm
  • bit10 - GPS antenna failure alarm
  • bit11 - GPS module failure alarm
lac Location Area Code
cell_id Cell ID
mcc Mobile country code
mnc Mobile network code
rx_lvl Signal strength
func_code Function code:
  • 1 - Call response
  • 2 - GPS data with base station information
  • 3 - GPS data at regular time
  • 6 - Single data compensation upload in GPRS blind area
  • 7 - Multi base station data
  • 9 - GPS data with base station information and cumulative time
  • 22 - Instruction return code
  • 45 - Upload message of Terminal
lock_st E-Lock status
rec_f_code Received function code
inst_code Instruction code
op_instr Operation instruction.
85 - operation reply.
cmd_code Command code
cmdsrc Command source:
  • 0 - SMS,
  • 1 - automatic
  • 2 - keyboard
  • 3 - handset,
  • 4 - center,
  • 5 - gate
voltage_st Voltaget status:
  • 48 - Serious low voltage
  • 49 - Too low voltage
  • 50 - Low voltage
  • 51-54 - Normal voltage
  • 55 - Full

If your device has 4-digits port in the configurator please enter 9010 port.