AR Series

AR Series
Fabricante: Oigo Telematics
Discusión en el foro

Cantidad de unidades

568
En línea
1255
Total
Soportado en Wialon:
  • Comunicación por UDP

Para que el sistema de rastreo Wialon identifique los datos de AR Series en el diálogo de configuración de la unidad, indique los siguientes datos :

Tipo de dispositivo: AR Series
ID único: imei

Indique los siguientes parámetros en el programa de configuración o en la configuración AR Series para utilizarlos en Wialon Hosting :

Puerto del servidor: 21126

En el centro de servicio Wialon se utilizan 1255 unidades AR Series — es 0.05% de la cantidad total de dispositivos Automóvil conectados.

La gráfica representa la cantidad de conexiones en el centro de servicio Wialon en los últimos 30 días:

Nombre del parámetro Descripción Unidades de medida
hdop An indication of the quality of the received signal
rssi Relative indication of the RF signal strength seen by the device
main_pwr Indicates the voltage of the power source 10 mV
backup_pwr Indicates the voltage of a secondary power source 10 mV
gpio_status GPIO Status
gpio_dir GPIO Direction
odometer Odometer km
baseband_ver Indicates the software release version of the baseband subsystem.
app_ver

Indicates the current release of the application running on a given
device.

assembly Board assembly
rev Indicates the revision of the assembly
io_ver Indicates the software release version of the I/O processor
change_bit Is set if the original configuration has been altered with one or more user commands
conf_num

Indicates the version of the configuration installed on the device

event

1 - Power-Up (Power up report)
2 - Heart Beat (Periodic report)
3 - BuB Heart Beat (Periodic report when running from backup battery)
4 - BuB On (Switched to backup battery (main power loss))
5 - BuB Off (Switched back from BuB to main power)
6 - Power Drop (External power dropped below +XPWL threshold)
7 - Power Restore (External power raised above +XPWL threshold)
12 - Relay High (RLY state changed from 0 → 1)
13 - Relay Low (RLY state changed from 1 → 0)
14 - Ignition High (Ignition state changed from low → high)
15 - Ignition Low (Ignition state changed from high → low)
16 - GPS Locked (Valid GPS)
17 - GPS Unlocked (Invalid GPS)
18 - IP Changed (Local IP address changed)
19 - Speeding Start (Speed raised above specified threshold)
20 - Speeding Stop (Speed dropped below specified threshold)
22 - Drive Trip - Start (Trip Started)
23 - Drive Trip - End (Trip Ended)
24 - Moving (Recurring event while in “trip” and moving)
25 - Stopped (Recurring event while stopped)
26 - Heading Change (Changed heading by a specified degree while in “trip”)
27 - Drive Distance (Recurring event passing specified distance while in “trip”)
28 - Tow Alert (Vehicle moving with ignition off)
30 - Idling Alert (Vehicle is Idle)
31 - Now Report (Response to Report Now command)
32 - Periodic Reset (Scheduled “reset” took place)
33 - Trip Odometer (Virtual Trip Odometer reached specified threshold)
34 - Maintenance (Maintenance Periodic Report)
37 - GP1 High (GP1 state changed from 0 → 1)
38 - GP1 Low (GP1 state changed from 1 → 0)
39 - GP2 High (GP2 state changed from 0 → 1)
40 - GP2 Low (GP2 state changed from 1 → 0)
41 - GP3 High (GP3 state changed from 0 → 1)
42 - GP3 Low (GP3 state changed from 1 → 0)
43 - GP4 High (GP4 state changed from 0 → 1)
44 - GP4 Low (GP4 state changed from 1 → 0)
64 - Power Save (External power dropped below +XPWS threshold)
65 - Power Normal (External power raised above +XPWS threshold)
96-111 - Geo-Fence Enter (Second digit of event indicates geo-fence number)
112-127 - Geo-Fence Exit (Second digit of event indicates geo-fence number)

All device models 2G, 3G, CDMA are supported.

Otros dispositivos del fabricante

Contacte con Wialon y logre los objetivos más ambiciosos con la telemática

Por favor, llene la solicitud para iniciar el trabajo con Wialon

Paso 1
Paso 2
Paso 3
Nombre y apellido*
Compañía*
Email*
Teléfono