Kylos

Kylos
Manufacturer: Starcom
Forum Discussion

Number of units

0
Online
0
Total
Supported in Wialon:
  • SMS sending of data
  • Communication via TCP
  • Communication via UDP

The following data should also be added to Kylos unit properties section of Wialon GPS tracking software :

Device type: Kylos
Unique ID: serial

Specify the following parameters in configuration software or configuration Kylos for use in Wialon Hosting :

Server port: 20856

0 units of Kylos device type are connected to Wialon Data Center. This represents 0% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name Description Units
arm Arm input state
blinker Blinker output state
disarm Disarm input state
door Door input state
emergency Emergency input state
engine_rpm Engine RPM rpm
eventid Event ID in case of a custom event
fuel Special algorithm for an analog input
gps_connected GPS device on/off
gps_valid GPS actual validity
gradualstop Gradualstop output state
hood Hood input state
ign Ignition input state
immobilizer Immobilizer output state
int_lights Int_lights output state
kind Type of packet
lock Lock output state
logic_state Logic states
mileage Kilometers counter km
odometer Odometer reading
pending If this value is '0' it means that no older messages than datetime_actual are left in the unit's memory
pwr_ext Input voltage V
pwr_int Battery level %
reason Transmit Reason (2 - Tracking)
response If the packet is a response to an incoming command value is 1
shock Shock input state
siren Siren output state
software_version Firmware version
trunk Trunk output state
unittype Unit type (0 - LCU500, 5 - Helios)
unlock Unlock output state
volume Volume input state

All Starcom devices use encrypted protocol and can't send data to Wialon directly. Customer should use special Starcom Routing Software on dedicated server. Please ask Starcom support about it.

More devices from the manufacturer

Contact Wialon and achieve the most ambitious goals with telematics

Fill out a request form to get started with Wialon

Step 1
Step 2
Step 3
First and last name*
Company*
Email*
Phone