Gosafe G6S

Gosafe G6S
Manufacturer: Gosafe
Forum Discussion

Number of units

419
Online
805
Total
Features Gosafe G6S:
  • 3G
  • Blackbox
  • GLONASS support
  • Built-in odometer
  • Voice calls
Supported in Wialon:
  • ADC sensors
  • Camera connection
  • Garmin support
  • Remote management via GPRS
  • Driver identification
  • Digital sensors
  • Communication via TCP

The following data should also be added to Gosafe G6S unit properties section of Wialon GPS tracking software :

Device type: Gosafe G6S
Unique ID: serial

Specify the following parameters in configuration software or configuration Gosafe G6S for use in Wialon Hosting :

Server port: 20759

805 units of Gosafe G6S device type are connected to Wialon Data Center. This represents 0.03% of all AVL Hardware connected.

Below chart represents the dynamic of connections in the last 30 days:

Parameter name Description Units
acc ACC status. 0 - off, 1 - on
avl_driver Serial number of ibutton
cidN The identifier of GSM base station N
device_status

Device status. Each bit represents one kind of event

Event status identifier

Bit Explanation Status 0 Status 1
Bit0 bExtPwr External power supply Normal Low or high
Bit1 bInterBat Backup battery Normal Low or high
Bit2 bMoving Moving Still Move
Bit3 bSpdOver Over speed Normal Over
Bit4 bIDiling Idle Normal Idle
Bit5 bTow Tow Normal Tow
Bit6 bAntiJam GSM jamming Normal Jamming
Bit7 bRoaming Domestic roaming Normal Roaming
Bit8 bInterRoam International roaming Normal Roaming
Bit9 bUrgent Harsh behavior Normal Harsh brake/accelerate
/cornering
Bit10 bAccIDent AccIDent Normal Front collision/Rear collision
/Turn over
Bit11 bGeoFence Geo-fence Normal In or out
Bit12 bAdc1 ADC1 input Normal Abnormal (Lower or higher)
Bit13 bAdc2 ADC2 input Normal Abnormal (Lower or higher)
Bit14 bStop Parking Parking Not parking
Bit15 bWorkStatus Private hour Normal Under private hour

diN_freq Digital input N frequency Hz
diN_pulse Digital input N pulse
dtt_event_status DTT data event status
engine_hours Engine hours hour
event_id Event ID
event_status Event status identifier
geo_fence Geofence number that is triggered
geo_fenceM_N Number M to N Geofences status. Each bit represents each Geofence, bit 0 to bit N-M+1 represents Geofence M to Geofence N. 0 - outside Geofence or there is no Geofence assigned to device, 1 - inside Geofence
geo_local_tm Local time when Geofence event is triggered
geo_speed Speed when Geofence event is triggered km/h
geo_status Bit field. Bit0: 1 - over speed, 0 - speed is normal. Bit1: 1 - inside Geofence, 0 - outside Geofence
gps_fix GPS fix. 1 - fixed, 0 - not fixed
gsm_level Signal strength, range is 0 to 5
lacN The zone code of GSM base station N
mccN Mobile country code (base station N)
mncN Mobile network code (base station N)
mileage Accumulated mileage of a vehicle m
omn_freq Frequency value. Omnicomm LLS fuel level sensor
omn_level Relative level. Omnicomm LLS fuel level sensor
omn_temp Temperature. Omnicomm LLS fuel level sensor °C
pwr_ext External power supply voltage Volt
pwr_int Backup battery voltage Volt
reg_status GSM registration status
rssiN Signal strength (base station N) dBm
sender_addr The network address of the message sender. Omnicomm LLS fuel level sensor
tsN Temperature sensor value. N - sensor serial number °C
x_axis_accel X axis acceleration magnitude value g
y_axis_accel Y axis acceleration magnitude value g
x_axis_brake X axis braking magnitude value g
y_axis_brake Y axis braking magnitude value g
x_axis_corner X axis cornering magnitude value g
y_axis_corner Y axis cornering magnitude value g
x_axis_fr_col X axis front collision magnitude value g
y_axis_fr_col Y axis front collision magnitude value g
x_axis_rear_col X axis rear collision magnitude value g
y_axis_rear_col Y axis rear collision magnitude value g
x_axis_turnover X axis turnover magnitude value g
y_axis_turnover Y axis turnover magnitude value g

More devices from the manufacturer

Contact Wialon and achieve the most ambitious goals with telematics

Fill out a request form to get started with Wialon

Step 1
Step 2
Step 3
First and last name*
Company*
Email*
Phone